30.6.3 multicast igmp qryvid delete Command
Syntax:
multicast igmp qryvid delete <vid>
This command removes an IGMP query VLAN ID. The following example removes IGMP
query VLAN ID 6.
ras> multicast igmp qryvid delete 6
30.6.4 multicast igmp qryvid set Command
Syntax:
ras> multicast igmp qryvid set <vid>
This command adds an IGMP query VLAN ID. When using IGMP proxy mode, the device
sends IGMP queries to the members of the specific VLANs. You can use this command to
define which VLANs the device sends queries only. You must have already used the
commands to create the VLAN before you use this command.
The following example sets VLAN ID 6 as an IGMP query VLAN.
ras> multicast igmp qryvid set 6
30.6.5 multicast igmp qryvid show Command
Syntax:
ras> multicast qryvid show
This command displays the IGMP query VLAN IDs.
ras> multicast igmp qryvid show
igmp proxy query vlan table
vid
static/dynamic
---- --------------
6 static
30.6.6 multicast igmp show Command
Syntax:
ras> multicast igmp show
This command displays the current IGMP settings. The following shows an example.
ras> multicast igmp show
proxy is enabled
mode is normal
igmp version is v3
igmp leave time: 0 sec
igmp fast leave: enable
MSC1000G/1024G/1224G Series User's Guide
Chapter 30 multicast Commands
vlan
677