Switch Dot3Ad Lacp Priority Command; Switch Dot3Ad Lacp Timeout Command; Switch Dot3Ad Lacp Show Command - ZyXEL Communications MSC1024G Series User Manual

34.6.1 switch dot3ad lacp priority Command

Syntax:
switch dot3ad lacp priority <priority>
where
<priority>
This command sets the LACP system priority.
This example sets the system's priority to 1000.
ras> switch dot3ad lacp priority 1000

34.6.2 switch dot3ad lacp timeout Command

Syntax:
switch dot3ad lacp priority timeout short|long
where
timeout
short|long
This command sets the time interval between exchanging LACP packets.
This example sets the system's to exchange LACP packets with the peer every second
ras> switch dot3ad lacp timeout short

34.6.3 switch dot3ad lacp show Command

Syntax:
switch dot3ad lacp show
This command displays the system's LACP settings. The following shows an example.
ras> switch dot3ad lacp show
priority : 1000
time out : short (1 sec)
ras>
MSC1000G/1024G/1224G Series User's Guide
LACP system priority is a number between 1 and 65,535. The switch with
=
the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP "server". The LACP "server" controls the
operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregate Control Protocol (LACP). The smaller the number,
the higher the priority level.
= Timeout is the time interval between the individual port exchanges of
LACP packets in order to check that the peer port in the trunk group is
still up. If a port does not respond after three tries, then it is deemed to be
"down" and is removed from the trunk. Set a short timeout (one second)
for busy trunked links to ensure that disabled ports are removed from the
trunk group as soon as possible. Select either short (1 second) or long
(30 seconds).
Chapter 34 switch Commands
881