The following example sets the switch to add "testing" as the line information to PPPoE
discover packets on VLAN 10.
ras> acl pppoeagent set 10
ras> acl pppoeagent enable 10
ras> acl pppoeagent info 10 testing
ras> acl pppoeagent show
vid
en
---- ----- ------------------------
10
V
vlan set: 1
ras>
21.12.6 acl pppoeagent optionmode Command
Syntax:
acl pppoeagent optionmode <vid> private|tr101 [vid on|off]
This command selects the method (Private or TR-101) in which PPPoE line information is
encoded in PPPoE discover packets on the specified VLAN, and whether the VLAN ID is
transmitted within the packet or not. The vid on|off option applies to the TR-101 mode
only. See
Section 11.12 on page 252
The following example sets VLAN 10 to use TR-101 encoding, and to transmit the VLAN ID
in PPPoE discover packets.
ras> acl pppoeagent optionmode 10 tr101 vid on
21.12.7 acl pppoeagent set Command
Syntax:
acl pppoeagent set <vid>
This command creates a PPPoE agent information entry for the VLAN. After you have created
an entry for a VLAN, you can configure the line information settings. The following example
creates an entry for VLAN 10.
ras> acl pppoeagent set 10
21.12.8 acl pppoeagent show Command
Syntax:
acl pppoeagent show
MSC1000G/1024G/1224G Series User's Guide
info
testing
for more information on Private and TR-101 modes.
Chapter 21 acl Commands
609