E1 Port Setup Line Card Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 11 Subscriber Port Setup Screens

Table 128 E1 Port Setup (continued)

11.30.1 E1 Port Setup Line Card Screen

Click Port > E1 in the navigation panel to open the E1 Port Setup screen. Click an active

IMA line card's ID number to open the following screen. Use this screen to enable/disable or

configure E1 ports on the line card.

Figure 192 E1 Port Setup: Line Card

Do the following to copy the settings you configure above to another port or ports.

1. Click Copy.

2. Select to which line card you want to copy the settings.

3. Select to which ports on the line card you want to copy the settings. Use Select All

to select every port. Use Select None to clear all of the check boxes.

4. Click Apply to paste the settings.

This column lists the slot numbers of the line cards. Click the ID number of an active

DSL line card to go to a screen where you can view and delete PVCs from the line

card's DSL ports.

This field displays the line card's current operational status.

active means the line card is operating normally.

init means the MSC is initializing the line card.

disable means a manager has disabled the line card.

inactive means the line card is starting up or is not operating normally. This could be

due to the card starting, a firmware upgrade in progress or a malfunction. See

39.7 on page 974

for what to do if the line card stays stuck in the inactive state.

This field displays the type of a line card.

This field displays how long the line card has been running since the last time it was

This field displays the current firmware version installed on the line card.

MSC1000G/1024G/1224G Series User's Guide

Msc1224g series Msc1000g series