ZyXEL Communications MSC1024G Series User Manual page 501

Figure 350 CFM Endpoint: MIP
The following table describes the labels in this screen.
Table 259 CFM Endpoint: MIP
LABEL
MD Name
MA Name
MSC1000G
Apply
Slot
Port
Load
Enable
Apply
Cancel
ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This displays the name of the MD for which you want to configure end points.
This displays the name of the MA for which you want to configure end points.
Select Enable and specify a MAC address to set a MIP on an MSC port.
Click Apply to save the changes in this section to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Use the drop-down list boxes to select a DSL port on a line card for which you
want to configure MIP settings.
Click Load to display the port's current settings.
Select Enable and specify a MAC address to set a MIP on a DSL port.
Click Apply to save the changes in this section to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields.
This is the slot number of a line card. Click the index number of an active line card
to display a screen that lists the MIP setting for each of the line card's ports.
Chapter 15 Switch Screens
501