Configuration Example - ZyXEL Communications MSC1024G Series User Manual

Select slot 7 and port 1, and click Load to display the settings as shown in this screen.
Select Enable and click Apply.
Figure 24 Enable the VDSL Port
6 Configure the IP address for A (for example, 192.168.1.33) and B (for example,
192.168.1.254).
7 Use the command "ping 192.168.1.254" in A's DOS mode to check the connection with
B.
If the ping response is successful, you can now (with the other settings set to the defaults)
provide service to DSL subscribers connected to the line card. See the appendices for
information on other default settings.
4.2 H.248 Configuration Example
This section provides an example of using configuring a VoIP line card to communicate with
an H.248 MGC (Media Gateway Controller). You should already have information about the
MGC's configuration.
Take the following steps to configure the line card.
MSC1000G/1024G/1224G Series User's Guide
Chapter 4 Tutorials
79