Switch Bcastctrl Show Command; Switch Cfm Commands - ZyXEL Communications MSC1024G Series User Manual

where
<giga-port>
<bc-limit>
<mc-limit>
<uu-limit>
This command sets the limitations of broadcast, multicast and unknown unicast packets, in
packets per second for each Gigabit Ethernet port.
This example sets the subtending 1 interface to accept up to 80,000 broadcast packets, 100,000
multicast packets and 60,000 unknown unicast packets per second.
ras> switch bcastctrl threshold sub1 80000 100000 60000

34.5.2 switch bcastctrl show Command

Syntax:
switch bcasctrl show
This command displays the broadcast storm control settings. The following shows an
example.
ras> switch bcastctrl show
port broadcast(pkt/s) multicast(pkt/s) uucast(pkt/s)
---- ---------------- ---------------- ----------------
sub1
sub2
up1
up2
ras>

34.5.3 switch cfm Commands

34.5.3.1 switch cfm disable
Syntax:
switch cfm disable
This command disables Connectivity Fault Management (CFM).
34.5.3.2 switch cfm enable
Syntax:
switch cfm enable
This command enables CFM.
MSC1000G/1024G/1224G Series User's Guide
= This represents Gigabit Ethernet uplink ports, subtending ports or all ports.
Use sub1|sub2|up1|up2|all i
sub|up|all if trunking is enabled.
= Sets how many broadcast packets the interface is allowed to receive per
second. 0~262143, use -1 to disable.
= Sets how many multicast packets the interface is allowed to receive per
second. 0~262143, use -1 to disable.
= Sets how many unknown unicast packets the interface is allowed to receive
per second. 0~262143, use -1 to disable.
80000 100000
- -
- -
- -
Chapter 34 switch Commands
f trunking is not enabled. Use
60000
-
-
-
875