ZyXEL Communications MSC1024G Series User Manual page 813

clir
calltransfer
fax g711
fax t38
flash
invite
rfc2833
rfc2833like
sipinfo1
sipinfo2
sipinfo3
sipinfo4
sipinfo5
sipinfo6
localcall
mwi
reanswer
ra
This command creates and configures a SIP call service profile. The values of the default SIP
call service profile are as follows:
• Password: none.
• Key pattern table: DEFVAL
• Registration timeout: on 3600 seconds
• DND: on
• Call holding: on
• Call waiting: on
• Call return: on
• CLIP: on
• CLIR: on
• Call transferring: on
• CIDCW: on
• fax: G.711
• DTMF: bypass
• Local call: off
MSC1000G/1024G/1224G Series User's Guide
= Caller Line Identification Restriction allowed/prohibited.
= Call transferring allowed/prohibited.
The system relays fax signals according to ITU-T G.711.
=
The system relays fax signals according to ITU-T T-38.
=
= Select the method the system uses to process the flash signal from a user.
Relays flash by SIP INVITE signal.
=
Relays flash according to RFC 2833.
=
= Relays flash in SIP INFO packets, but carried as RFC 2833 payload
= Relays flash in SIP INFO packets (a signal=16 message)
Relays flash in SIP INFO packets (a signal=hf message)
=
Relays flash in SIP INFO packets (a signal=hook-flash message)
=
= Relays flash in SIP INFO packets (a plain text "FLASH" message).
= Relays flash in SIP INFO packets (multiple SIP messages). The message
content is determined by the characters you enter for <rc>. A separate SIP
INFO message is sent for each character you enter.
Relays flash in SIP INFO packets (where the content of the message is
=
determined by the text you enter for <si>).
= Sets whether or not to allow subscribers to call other subscribers if the
system's connection to the SIP server is not available.
= Turns the message waiting indicator on or off.
= When the system is using v5sip mode, use this field to set the reanswer
time period. The reanswer time controls the length of time between the user
hanging up the phone, and the call being disconnected (the BYE request
being sent).
= The reanswer time period in seconds (0-30) after the user hangs up the
phone before disconnecting the call.
Chapter 32 profile Commands
813