Sys Server Port Command; Sys Server Disable Command; Sys Server Enable Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 35 sys Commands
The following example shows the administrator at IP address 123.23.19.11 ordering a reboot
to occur after 1200 seconds, displaying the reboot schedule and then canceling the reboot.
ras> sys reboot 1200
telnet-1(123.23.19.11) has initiated reboot, system reboot in 1200 seconds!
ras> sys reboot show
issued by
-------------------------- -------------- ------------------------
telnet-1(123.23.19.11)
ras> sys reboot cancel
telnet-1(123.23.19.11) has cancelled system reboot!

35.3.27 sys server port Command

Syntax:
sys server port telnet|ftp|web|snmp|ssh <port>
This command changes the port for a service on the system.
The following example sets the system to use port 24 for Telnet sessions.
ras> sys server port telnet 24

35.3.28 sys server disable Command

Syntax:
sys server enable telnet|ftp|web|snmp|ssh
This command turns off access for a service on the system.
The following example sets the system to block Telnet sessions.
ras> sys server disable telnet

35.3.29 sys server enable Command

Syntax:
sys server enable telnet|ftp|web|snmp|ssh
This command turns on access for a service on the system.
The following example sets the system to allow Telnet sessions.
ras> sys server enable telnet
922
remaining time issue time
1196 Wed Jun
MSC1000G/1024G/1224G Series User's Guide
8 15:26:54 2005