Alarm Shdsl Profile Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 13 Profile Screens
Figure 226 Profile > Alarm VDSL2 > ChanProfile
The following table describes the labels in this screen.
Table 158 Profile > Alarm VDSL2 > ChanProfile
LABEL
Name
XTUC
XTUR
15 Min Coding
Violations
Threshold
15 Min Corrected
Blocks Threshold
Apply
New
Cancel
Index
Name
Modify
Delete

13.17 Alarm SHDSL Profile Screen

Click Profile> Alarm SHDSL in the navigation panel to open the following screen. Use this
screen to configure alarm profiles for the SHDSL ports. Later you can apply the alarm SHDSL
profiles to SHDSL ports in the SHDSL Port Setup screens.
Alarm SHDSL profiles define SHDSL port alarm thresholds. The system sends an alarm trap
and generates a syslog entry when the thresholds of the alarm profile are exceeded.
360
DESCRIPTION
Enter a descriptive name for identification purposes.
Configure the thresholds in this column for the system (XTUC).
Configure the thresholds in this column for CPE devices (XTUR).
Enter the number of Code Violation (incorrect cyclic redundancy check) that are
permitted to occur within 15 minutes.
Enter the number of error blocks that can be corrected within 15 minutes.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the index number of the alarm profile.
This field displays the descriptive name for the VDSL channel alarm profile.
Select a profile's Select radio button and click Modify to edit the profile.
Select a profile's Select radio button and click Delete to remove the profile.
MSC1000G/1024G/1224G Series User's Guide