ZyXEL Communications MSC1024G Series User Manual page 956

Chapter 37 voip Commands
where
[name]
If a keypattern profile is not specified, this commands lists configured keypattern profiles.
When a profile is specified this command shows the settings of the specified profile, in this
case the default keypattern profile "DEFVAL".
ras> voip sip keypattern show
KeyPattern Name(s):
----------------------
1. DEFVAL
2. keypattern1
ras> voip sip keypattern show DEFVAL
KeyPattern Name : DEFVAL
service type
---------------- ----------------
callreturn
calltransfer
callwaitdisconn
callwaitoff
callwaiton
callwaitonhold
callwaitreject
clir
dndoff
dndon
callin
repeat dialing
The following table describes the settings of a keypattern profile.
keyPattern name
service type
pattern
callreturn
calltransfer
callwaitdisconn
callwaitoff
callwaiton
callwaitonhold
callwaitreject
956
= The name of the keypattern profile (<=32 characters).
pattern
*97#
*98#
1
#43#
*43#
2
0
##
#99#
*99#
#14
*66:
The name of the keypattern profile (<=32 characters).
This describes the feature configured in this keypattern profile.
=
The pattern describes the telephone keys a user presses to access a
=
particular service. Characters are limited to the numerals 0~9, the
pound (#) and asterisk (*).
= Enter the sequence of keys the user presses to dial the phone
number of the last incoming call (1~7 characters).
Enter the sequence of keys the user presses to enable a call transfer
=
(1~7 characters).
Enter the key the user presses to disconnect a current call and accept
=
a waiting call (one character only).
Enter the sequence of keys the user presses to turn call waiting off
=
(1~7 characters).
Enter the sequence of keys the user presses to enable call waiting
=
(1~7 characters).
Enter the key the user presses to place a current call on hold and
=
accept a waiting call (one character only).
Enter the key the user presses to reject a waiting call (one character
=
only).
MSC1000G/1024G/1224G Series User's Guide