Chapter 26 diagnostic Commands
Specify the MD name, MA name, MEP ID, destination (MEP ID or MAC address) to perform
a loopback test.
The following shows an example.
ras> diagnostic cfm loopback testmd testma 1 2
loopback repId 2
received response
ras> diagnostic cfm loopback testmd testma 1 00:13:49:00:00:02
loopback 00:13:49:00:00:02
received response
26.4.2 diagnostic cfm linktrace show Command
Displays a link trace test report.
Syntax:
diagnostic cfm linktrace show <md-name> <ma-name> <ep-id> [<ltm-id> [ltr-
index]]
where
md-name
ma-name
ep-id
ltm-id
ltr-
index
Use this command to display the most recent loop diagnostic mode test results for an ADSL or
VDSL port. Use the loop diagnostics results to analyze problems with the physical ADSL or
VDSL line.
Wait at least one minute after using the
before using the
The following example performs loop diagnostics on DSL port 5 of the line card in slot 2.
The command then displays the results of the VDSL port loop diagnostics.
ras> diagnostic linktrace show 2-5
26.4.3 diagnostic cfm linktrace set Command
This enables the MEP port (with the specified MEP ID) in a specified CFM domain to send the
LTMs (Link Trace Messages) to a specified remote end point.
636
=
The maintenance domain name (length<32).
The maintenance association name (length<16)
=
The endpoint identifier (1~8191).
=
=
This is the index number of the link trace messages sent in a link trace test.
=
This is the index number of the link trace responses received in the system in a
link trace test.
diagnostic linktrace show
diagnostic linktrace set
command.
MSC1000G/1024G/1224G Series User's Guide
command