Voip Ip Show Command; Voip Route Commands; Voip Route Delete Command; Voip Route Set Command - ZyXEL Communications MSC1024G Series User Manual

37.8.3 voip ip show Command

Syntax:
voip ip show <slot>
This command shows the IP address, VLAN ID and DNS server IP address used by the
specified VoIP line card.
The following example shows the information for the VoIP line card in slot 4.
ras> voip ip show 4
slot ip/mask
==== ================== === ===============
4 111.11.11.1

37.9 voip route Commands

Use these commands to manage static routes for VoIP traffic.

37.9.1 voip route delete Command

Syntax:
voip route delete <slot> default|<ip-address>[/<netmask>] [<gateway>]
where
<ip-
address>
<netmask>
<gateway>
This command removes a static, IP forwarding route for VoIP traffic.
The following example removes a static route for destination IP address 192.23.19.233
through a gateway at IP address 192.23.15.253 from slot 4.
ras> voip route delete 4 192.23.19.233 192.23.15.253

37.9.2 voip route set Command

Syntax:
voip route set <slot> default|{<ip-address>[/<netmask>]} <gateway-ip>
[<metric>]
where
<ip-address>
<netmask>
MSC1000G/1024G/1224G Series User's Guide
vid dns
/24 22 123.44.55.66
The destination IP address of packets to which this static route applies.
=
= The destination subnet mask of packets to which this static route applies.
= The IP address of the gateway through which the packets are sent.
The destination IP address of packets that this static route is to route.
=
The destination subnet mask of packets that this static route is to route.
=
Chapter 37 voip Commands
951