ZyXEL Communications MSC1024G Series User Manual page 199

Figure 115 Multicast > IGMP > Bandwidth
The following table describes the labels in this screen.
Table 68 Multicast > IGMP > Bandwidth
LABEL
Default
Bandwidth
Index
Start Mcast Ip
End Mcast Ip
Bandwidth
Apply
New
Cancel
Index
Start Mcast Ip
End Mcast Ip
Bandwidth
Modify
Delete
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select the maximum bandwidth allowed for multicast traffic for which you have not
configured bandwidth requirements yet. The multicast bandwidth settings on ports
(see the Bandwidth field below) have higher priority over this default setting. Click
Apply to save the changes in this section to the system's volatile memory.
Specify the index number of a multicast group.
Enter the start IP address in the range of multicast IP addresses to which the
bandwidth setting applies.
Enter the end IP address in the range of multicast IP addresses to which the
bandwidth setting applies
Select Enable to enable bandwidth control and type a maximum bandwidth (in
kbps) allowed for the traffic flow on a port.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
After you click Apply, entries display in the first table so you can edit them. Click
New if you want to configure a different static multicast group.
Click Cancel to begin configuring the screen again.
This displays the index number of records in the multicast group bandwidth control
table.
This displays the start IP address in the range of multicast IP addresses to which
the bandwidth settings applies.
This displays the end IP address in the range of multicast IP addresses to which the
bandwidth settings applies.
This displays specified the bandwidth applied to the multicast hosts.
Select a multicast group's radio button and click Modify to display the multicast
group in the table above so you can edit it.
Select a multicast group's radio button and click Delete to remove the multicast
group.
Chapter 10 Multicast Screens
199