Loop Guard Slot Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 5 Access Control List Screens

Table 37 ACL > Loop Guard (continued)

5.20.1 Loop Guard Slot Screen

Click the slot number of an active line card in the ACL > Loop Guard screen to display the

screen shown next. Use this screen to copy a port's loop guard settings to other ports.

Figure 74 ACL > Loop Guard: Slot

The following table describes the labels in this screen.

Table 38 ACL > Loop Guard: Slot

This field displays how long the line card has been running since the last time it was

This field displays the current firmware version installed on the line card.

Click UP to go back to the previous screen.

Do the following to copy settings from one port to another port or ports.

1. Select the Select radio button of the port from which you want to copy settings

2. Click Copy.

3. Select to which line card you want to copy the settings.

4. Select to which ports on the line card you want to copy the settings. Use Select

All to select every port. Use Select None to clear all of the check boxes.

5. Click Apply to paste the settings.

This field displays the number of the DSL port.

This field displays whether loop guard is enabled or disabled for this individual

This field displays the port's loop guard mode.

For fix, the system shuts down the port when the system detects that packets sent

out on the port loop back to the system. To activate the port again, you need to

manually enable the port in the Port Setup screen.

For dynamic, the system shuts down the port if the system detects that packets

sent out on the port loop back to the system. The port becomes active

automatically after the time specified in the Time field.

MSC1000G/1024G/1224G Series User's Guide

Msc1224g series Msc1000g series