Chapter 33 show Commands
The following table describes labels in this example.
Table 332 show adsl tssi Command Display
LABEL
near end/far
end
tone
33.3.2 show arp Command
Syntax:
show arp
This command displays the system's IP Address Resolution Protocol table. This is the list of
IP addresses and matching MAC addresses that the system has resolved.
An example is shown next.
ras> show arp
ip address
--------------- ----- ----------------- ----------
123.23.14.26
123.23.14.76
123.23.14.91
123.23.14.98
123.23.15.97
123.23.15.172
123.23.15.254
arp entry: 7
33.3.3 show atm Command
Syntax:
show atm <slot-port>|<slot-port-vpi/vci> [reset]
This command displays ATM traffic counters. It can also reset the counters.
830
DESCRIPTION
This shows the location of the line test. "near end" refers to upstream traffic, or
traffic from the CPE device. "far end" refers to downstream traffic, or traffic from
the CO device.
This shows the frequency in increments of 4.3125 KHz. Single digit units on the
top row are added to the units in tens on the left hand column to find the
corresponding value in the table. For example, to find the TSSi value for tone band
43, locate 40 in the left hand column and 3 in the top row. The intersection of the
column 3 and row 40 gives a TSSi value of 5.
time ether address
290 00:0d:60:cc:14:e9 outband
290 00:00:e8:97:70:64 outband
290 00:0a:e4:0a:76:21 outband
290 00:50:70:ff:f3:89 outband
300 08:00:46:74:0e:a5 outband
300 02:0e:a6:89:41:60 outband
300 00:04:80:9b:78:00 outband
interface
MSC1000G/1024G/1224G Series User's Guide