Radius Server Setup - ZyXEL Communications MSC1024G Series User Manual

Table 274 Sys > AAA (continued)
LABEL
Active
Broadcast
Mode
Method
Privilege
Apply
Cancel
External Server
RADIUS
TACACS+

16.9.4 RADIUS Server Setup

Use this screen to configure your RADIUS server settings. See
more information on RADIUS servers and
utilized by the authentication and accounting feature on the system. Click the RADIUS
Advance button in the Sys > AAA screen to view the screen as shown.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select this to activate accounting for a specified event types.
Select this to have the system send accounting information to all configured
accounting servers at the same time.
If you don't select this and you have two accounting servers set up, then the system
sends information to the first accounting server and if it doesn't get a response from
the accounting server then it tries the second accounting server.
The MSC supports two modes of recording login events. Select:
start-stop: to have the system send information to the accounting server when a
user begins a session, during a user's session (if it lasts past the Update Period),
and when a user ends a session.
stop-only: to have the system send information to the accounting server only when
a user ends a session.
Select whether you want to use RADIUS or TACACS+ for accounting of specific
types of events.
TACACS+ is the only method for recording Commands type of event.
This field is only configurable for Commands type of event. Select the threshold
command privilege level for which the system should send accounting information.
The system will send accounting information when commands at the level you
specify and higher are executed on the system.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config
Save on the navigation panel and then the Save button to save your changes to the
non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to go to screens where you can configure your authentication
server settings (RADIUS, TACACS+ or both)
Click Advance to go to the screen where you can configure RADIUS authentication
server settings.
Click Advance to go to the screen where you can configure TACACS+
authentication server settings.
Section 16.9.2 on page 521
Section 16.10 on page 528
Chapter 16 Sys Screens
for
for RADIUS attributes
523