Port Adsl Pmm Enable Command; Port Adsl Power Command - ZyXEL Communications MSC1024G Series User Manual

The following example sets ADSL2+ port 5 on the line card in slot 7 to not use power
management.
ras> port adsl pmm disable 7-5

31.4.13 port adsl pmm enable Command

Syntax:
port adsl pmm enable <slot-port> [L2|L3]
where
=
L2
=
L3
This command turns on the Power Management Mode (PMM) feature on the specified
ADSL2/2+ port(s). This reduces the amount of power used overall and reduces the instances
of the connection going down. PMM increases or decreases the transmission power based on
line conditions.
The following example sets ADSL2+ port 5 on the line card in slot 7 to use power
management.
ras> port adsl pmm enable 7-5

31.4.14 port adsl power Command

Syntax:
port adsl power <slot-port> fix|power|rate <max_us_txpwr> <max_ds_txpwr>
<max_rxpwr>
where
fix|power|rate
<max_us_txpwr>
MSC1000G/1024G/1224G Series User's Guide
Power management mode L2. This is a power saving mode that scales back the
power usage to where there is just enough to support the transmission rate that the
subscriber is using.
Power management mode L2 and L3. Power management mode L3 is a power
saving mode that puts the ADSL connection to sleep when there is no traffic. The
connection comes back up within three seconds when there is traffic.
The PSD (Power Spectral Density) and power adaptivity mode.
=
: Fixed mode sets the maximum downstream transmit power to
fix
the number you specify (
power:
priority over the transmission rate. The line card attempts to reduce
its transmit power as much as possible while still maintaining the
configured minimum rate. This only applies to the downstream
connection and the ADSL operational mode must be G.dmt, ANSI
T1.413 or G.lite.
rate : Rate mode gives the transmission rate priority over the
saving of transmission power. The line card attempts to achieve the
maximum configured transmission rate before reducing the transmit
power.
= Maximum upstream transmit power, -130~200 in 0.1 dBm.
<max_ds_txpwr>).
Power mode gives the saving of transmission power
Chapter 31 port Commands
705