Port Ipbpvc Route Show Command - ZyXEL Communications MSC1024G Series User Manual

<nexthop>
<metric>
<priority>
This command creates the specified entry in the routing table of the specified domain.
The
<ip-address>
the destination IP address of a packet is in this range, the system forwards the frame to the
specified IP address <nexthop>. If <nexthop> corresponds to an edge router configured
using the edge router commands (see
associated VLAN ID. In addition,
• If the edge router is in the same domain as the entry, the entry is used for upstream traffic.
• If the edge router is in a different domain than the entry, the entry is used for downstream
traffic.
If <nexthop> is not set up in the edge router screen, the system uses the entry for
downstream traffic and does not change the VLAN ID.
If the <priority> is not specified, the default value is zero. This is applied to incoming
frames without a <priority> tag.
The following example creates an entry in the routing table for domain "example3". This entry
forwards traffic for IP addresses 192.168.4.0~192.168.4.255 to edge router 192.168.1.244.
ras> port ipbpvc route set example3 192.168.4.0/24 192.168.1.244 1

31.22.3 port ipbpvc route show Command

Syntax:
port ipbpvc route show [all|<domain-name>|<ip/mask>|<domain-name><ip-
address>/<mask>]
where
<domain-name> =
<ip/mask>
This command displays routing table entries created manually for the specified domain and/or
range of IP addresses. It does not show entries added automatically by the system.
MSC1000G/1024G/1224G Series User's Guide
IP address, in dotted decimal notation.
=
The metric <1..15> represents the "cost" of transmission for routing
=
purposes. IP routing uses hop count as the measurement of cost, with
a minimum of 1 for directly-connected networks. Select the number that
approximates the cost for this link The number need not be precise, but
it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
If two entries have the same metric, the system uses the one with the
lower IP address.
The IEEE 802.1p priority value <0> ~ <7>.
=
/<mask> specifies the range of IP addresses to which this entry applies. If
Section 31.20 on page
The name of the domain.
IP address, in dotted decimal notation and number of bits <0..32> in the
=
subnet mask.
Chapter 31 port Commands
722), the system uses the
727