ZyXEL Communications MSC1024G Series User Manual page 277

Figure 171 SHDSL Pair Bonding Example
The following shows how to use the G.bond Setup screen to configure port bonding settings.
Before you begin you need to have an active ADSL or SHDSL line card installed and
connected to multiple DSL lines.
1 Click Port > G.bond to open the G.bond Setup screen.
2 Select the ID number of an active ADSL or SHDSL line card in the Slot field.
3 You can create a new group of DSL lines on which to use port bonding, or edit an
existing group's details.
• To create a new group, click New.
• To edit an existing group, select a group from the Group drop down field and click
Load.
4 Type a descriptive name in the Name field to identify a group of DSL lines connecting
the ISP with the end-user, for example "Group1".
5 Click the link next to Member Port to configure the ports for this set of DSL lines. A
popup list of ports appears.
6 Select the ports to be used by the DSL line group and click Apply. Ports may not be
shared between line groups. For example, if port 1 belongs to "Group1", it may not
belong to "Group2".
• G.bond on ADSL lines only supports pairs of ports (1, 2), (3, 4) and so on up to (47,
48).
• G.bond on SHDSL lines supports multiple ports (up to 16).
7 Click Apply in the Port > G.bond screen to complete setup of the G.bond settings.
MSC1000G/1024G/1224G Series User's Guide
Chapter 11 Subscriber Port Setup Screens
A
Internet
B
277