ZyXEL Communications MSC1024G Series User Manual page 363

Figure 228 IGMP Filter Profile
The following table describes the fields in this screen.
Table 160 IGMP Filter Profile
LABEL
Name
Start IP
End IP
Apply
New
Cancel
Index
Name
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Type a name to identify the IGMP filter profile (you cannot change the name of the
DEFVAL profile). You can use up to 31 English keyboard characters; spaces are
not allowed.
Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.If you want to add a single multicast IP
address, enter it in both the Start IP and End IP fields.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the index number of the IGMP profile.
This is the name of the IGMP profile.
Chapter 13 Profile Screens
363