ZyXEL Communications MSC1024G Series User Manual page 877

34.5.3.7 switch cfm ma meplist delete
Syntax:
switch cfm ma meplist delete <md-name> <ma-name> <mep-id>
where
<mep-id>
This command deletes a list of maintenance association end points. The following example
deletes the end point identifier "2" from the list of end point identifiers for the maintenance
association "ma1" in the maintenance domain "md1".
ras> switch cfm meplist delete md1 ma1 2
34.5.3.8 switch cfm ma meplist set
Syntax:
switch cfm enable <md-name> <ma-name> <mep-id>
This command sets a list of maintenance association end points. The following example sets
the end point identifier "2" in the list of end point identifiers for the maintenance association
"ma1" in the maintenance domain "md1".
ras> switch cfm ma meplist set md1 ma1 2
34.5.3.9 switch cfm ma set
Syntax:
switch cfm ma set <md-name> <ma-name> <primary-vlan> [<cci-interval>]
where
<primary-
vlan>
<cci-
interval>
This command sets a maintenance association. The following sets up the maintenance
association "ma1" with the primary VLAN identified by 2 and a CCI interval of 7 (10
minutes).
ras> switch cfm ma set md1 ma2 2 7
MSC1000G/1024G/1224G Series User's Guide
= The end point identifier.
= The primary served VLAN of this association.
The continuity check message initiation interval. The range is 4~7 where:
=
4: 1 s
5: 10 s
6: 1 min
7: 10 min
Chapter 34 switch Commands
877