Switch Oam Setup - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

15.18 Switch OAM Setup

To configure Ethernet OAM (Operational, Administration and Maintenance) settings for the

Ethernet line card ports, click Switch > OAM.

Figure 354 Switch > OAM

The following table describes the labels in this screen.

Table 263 Switch > OAM

MSC1000G/1024G/1224G Series User's Guide

Select an Ethernet line card and slot number and click Load to show details.

Select this to turn on OAM functionality for the selected Ethernet line card port.

Select active to allow the port to initiate or respond to OAM status exchange requests.

Select passive to have the port respond to OAM status exchange requests but not

initiate them.

Select this to have this port be able to send or respond to remote loopback tests. OAM

must also be enabled with the mode set to active for the port to be able to send remote

loopback tests.

Click Apply to save the changes in this section to the system's volatile memory. The

system loses these changes if it is turned off or loses power, so use the Config Save

on the navigation panel and then the Save button to save your changes to the non-

volatile memory when you are done configuring.

Click Cancel to reset the fields.

Chapter 15 Switch Screens

Msc1224g series Msc1000g series