ZyXEL Communications MSC1024G Series User Manual page 690

Chapter 31 port Commands
Table 325 port Commands (continued)
COMMAND
copy <source>
<destination>
disable <slot-port>
dtpvc delete <slot-
port-vpi/vci>
mvlan disable
mvlan enable
set
dtpvc show
e1 alarmprof
impedance
frame
timingsrc
enable <slot-port>
690
<slot-port-vpi/
vci>
<slot-port-vpi/
vci>
<slot-port-vpi/
vci> <profile>
<mux> <svid> <spri>
<cvid> <cpri>
<slot>|<slot-port>
<slot-port>
<profile>
<slot-port> 75|120
<slot-port>
cas|crc|cascrc
<slot-port>
local|<port>
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Copies port settings from a source port to
destination ports on the same type of line
card.
Turns off a subscriber port.
Removes the specified DTPVC.
Turns off MVLAN for the specified DTPVC. M
Turns on MVLAN for the specified DTPVC. M
Configures a DTPVC on the specified
subscriber port.
Displays the DTPVC configuration for the
specified subscriber slot or port.
Sets the alarm profile for the specified E1
port to define the thresholds that trigger an
alarm on the port when exceeded. You can
configure E1 alarm profiles using the
profile alarme1 set command.
profile: The name of an E1 alarm
profile.
Sets the E1 impedance. Use 75 for coaxial
cabling or 120 for twisted pair cabling.
Sets the circuit framing for the E1 line.
Both peers must use the same framing
setting.
cas: Channel associated signaling.
crc: Clear channel signaling (CRC4
multiframe format).
cascrc: Channel associated signaling
(CRC4 multiframe format).
Sets the time source of the specified E1
port.
Use local to have the port use the clock
of the IMA line card. Alternatively, type the
number of an E1 port (1~8) to have the
port use the clock of the remote connected
ADM device through the E1 line you select
here.
Note: This setting only works when
the clock setting of the IMA
group to which the E1 port
belongs is itc. See the ima
group clk set command
in Table 318 on page
Turns on a subscriber port.
P
M
M
M
M
L
M
M
M
645.
M