Enet Port Setup Line Card Screen - ZyXEL Communications MSC1024G Series User Manual

Table 122 ENET Port Setup (continued)
LABEL
Up Time
Firmware

11.28.1 ENET Port Setup Line Card Screen

Click Port > ENET in the navigation panel to open the ENET Port Setup screen. Click the
slot number of an active Ethernet line card to open the following screen. Use this screen to
configure settings for individual Ethernet ports and copy settings between ports.
Figure 185 ENET Port Setup: Line Card
The following table describes the fields in this screen.
Table 123 ENET Port Setup: Line Card
LABEL
UP
Copy
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Click this to return to the previous screen.
Do the following to copy settings from one Ethernet port to another Ethernet port
or ports.
1. Use the Select column to choose an Ethernet port from which you want to
copy settings.
2. Click Copy to open the following screen.
Figure 186 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the ports on the line card to which you want to copy
the settings. Click Select All to mark all of the port check boxes or click Select
None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Chapter 11 Subscriber Port Setup Screens
293