ZyXEL Communications MSC1024G Series User Manual page 287

Table 119 Port > VoIP H248 Screen
LABEL
Impedance
Apply
Cancel
Copy
Slot
Start Port
End Port
Termination
Step
Apply
ID
State
MSC1000G/1024G/1224G Series User's Guide
Chapter 11 Subscriber Port Setup Screens
DESCRIPTION
This field displays the default VoIP port AC impedance. The default
impedance value depends on the country code (configured in the VoIP >
Countrycode screen).
If you do not want to use the default impedance, select the required AC
impedance of the VoIP port from the drop-down list.
Click this to save your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click this to begin configuring the fields again.
Use this to assign a port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 179 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select
All to select every port. Use Select None to clear all of the check
boxes.
4. Click Apply to copy the settings, or click Cancel to close the window
without saving any changes.
Use the drop-down list boxes to select a range of ports on an active VoIP
line card for which to automatically configure names for their
Terminations.
Enter the name for this range of ports' H.248 Termination. Enter up to 31
alphanumeric characters. Spaces are not allowed.
Enter the interval between numbers to add to the name you configure in
the Termination field.
For example, enter "test" in the Termination field and "1" in the Step field
to name the ports test1, test2, test3, and so on.
Click this to save your changes to the MSC's volatile memory. The MSC
loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
This column displays the line card's slot number. Click a H.248 line card's
number to go to the card's H.248 Port Setup Line Card screen (see
Section 11.26 on page 288) where you can see and edit all a SIP line
card's VoIP configuration in a single screen.
This displays Active if the line card is enabled, or - if a line card is not
enabled.
287