The following example displays the ATM traffic counters for DSL port 5 on the line card in
slot 7.
ras> show atm 7-5
port 7-5
rx cells
tx cells
rx rate
tx rate
crc errors
The following table describes labels in this example.
Table 333 show atm Command Display
LABEL
rx cells
tx cells
rx rate
tx rate
crc errors
since pvc
create
since last
reset
33.3.4 show cfm Command
Syntax:
show cfm mep
This command displays all CFM maintenance end point information.
The following is an example.
ras> show cfm mep
maintenance domain : MD_0
maintenance association : L2SW-DSLAM
MEP id status
------ ------- ----------------- ----------------- ------------------
1
local 00:13:49:98:23:4c connection active
33.3.5 show dot3ad Command
Syntax:
show dot3ad [<slot>]
This command displays the (IEEE 802.3ad) link aggregation settings.
MSC1000G/1024G/1224G Series User's Guide
since pvc create
-------------------- --------------------
:
:
(byte/s):
(byte/s):
:
DESCRIPTION
This field shows the number of ATM cells received on this port.
This field shows the number of ATM cells transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of Cyclic Redundancy Check errors on this port.
This column displays the ATM traffic statistics that have accumulated from when
the PVC was created (either via command or the building of the DSL link).
This column displays the ATM traffic statistics that have accumulated from the
most recent time that the counters were reset.
mac
Chapter 33 show Commands
since last reset
0
0
0
0
0
state
LastFailedOkUpTime
0
0
0
0
0
831