ZyXEL Communications MSC1024G Series User Manual page 496

Chapter 15 Switch Screens
Figure 346 Switch Port Setup: DSCP
The following table describes the labels in this screen.
Table 255 Switch Port Setup: DSCP
LABEL
Port
Enable
Apply
Cancel
DSCP mapping
(codepoint/
priority)
Apply
Cancel
496
DESCRIPTION
This is the label of a Gigabit Ethernet interface.
Select Enable to map DSCP (priorities) for individual ports.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use the fields to set a DSCP service level (codepoint) to which the system should
change the DSCP service level.
Use the drop-down list boxes to select an IEEE 802.1p priority to which the
Device should change the DSCP service level.
For example, to find the IEEE 802.1p priority level for DSCP service level 43, find
40 in the left hand column and 3 in the top row. The intersection of the 3 column
and 40 row shows a priority setting of 5.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
MSC1000G/1024G/1224G Series User's Guide