Table of Contents
Advertisement
Table 72 Static MAC Multicast Slot (continued)
LABEL
Apply
Cancel
10.6 MVLAN Setup Screen
Multicast VLAN allows one single multicast VLAN to be shared among different subscriber
VLANs on the network. This improves bandwidth utilization by reducing multicast traffic in
the subscriber VLANs and simplifies multicast group management.
Click Multicast > MVLAN in the navigation panel to display the screen shown next. Use this
screen to configure MVLAN groups in this screen.
Figure 120 MVLAN Setup
The following table describes the labels in this screen.
Table 73 MVLAN Setup
LABEL
Enable
Name
VID
Priority
Index
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to close the screen without saving your changes.
DESCRIPTION
Select this check box to turn on the MVLAN.
Enter a descriptive name for this MVLAN for identification purposes.
Enter the VLAN ID (VLAN Identifier) for this MVLAN; the valid range is between 1
and 4094.
Specify the IEEE 802.1p priority (0~7) to use for this MVLAN's traffic. The system
changes the priority in IGMP protocol messages snooped on a member subscriber
port to the priority you specify here.
This field displays the number of the card in this list. Click a non-management card's
index number to open a screen where you can edit the membership settings of the
cards ports.
Chapter 10 Multicast Screens
205
Advertisement
Table of Contents
Troubleshooting
