Switch Setup Isolation Screen - ZyXEL Communications MSC1024G Series User Manual

15.8 Switch Setup Isolation Screen

Click Switch > Switch Setup > Isolation to display the screen as shown.
Figure 330 Switch Setup Isolation
The following table describes the labels in this screen.
Table 245 Switch Setup Isolation
LABEL
Port Isolation
Enable
Apply
Cancel
Add Isolation
VLAN
VID
Add
Index
VLAN ID
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Turn on port isolation to block communications between subscriber ports. When
you enable port isolation you do not need to configure the VLAN to isolate
subscribers.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
The isolation VLAN fields display if you disable Port Isolation.
Use isolation VLANs to block communications between subscribers in different
VLANs if you do not block communications between subscriber ports.
For example, you might want to isolate some VLAN (for example, high-speed
Internet) and not isolate other VLAN (for example, VoIP).
Specify the number of a VLAN for which you want to block communications with
other VLANs.
Click Apply to save your changes to the MSC's volatile memory.
The MSC loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
This field displays the index number of the isolated VLAN.
This field displays the number of a VLAN for which communications with other
VLAN are blocked.
Chapter 15 Switch Screens
479