ZyXEL Communications MSC1024G Series User Manual page 307

The following table describes the fields in this screen.
Table 132 Port > Xvlan: Line Card
LABEL
UP
Delete
Index
Port
Cvid
Svid
Cvid-S
Select
Select All
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the previous screen.
Select one or more entries' Select radio buttons and then click Delete to remove
them.
This is the number of an xVLAN entry on this port.
This is the number of a DSL port on the line card.
This is the original customer VLAN ID. When the port receives traffic from the
subscriber with this VID, it applies this xVLAN entry's settings before forwarding it
to the service provider's network.
Note: For ports with xVLAN entries, the system drops tagged traffic
from the subscriber that does not match an xVLAN entry.
To forward untagged traffic from a subscriber port that has xVLAN entries,
configure an xVLAN entry with the port's PVID as the Cvid. The system assigns
the port's PVID to untagged packets from the subscriber and then checks against
the port's xVLAN entries.
This is the service provider VLAN ID for use on the service provider's network.
This applies to the VLC13XXG cards. This is the translated customer VLAN ID for
use on the service provider's network.
Select an entry's Select check box and click Delete to remove the entry.
Clicking Delete saves your changes to the MSC's volatile memory.
The MSC loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Select this check box to select all of the column's check boxes. Clear this check
box to clear all of the column's check boxes.
Chapter 11 Subscriber Port Setup Screens
307