Ipb Route Screen - ZyXEL Communications MSC1024G Series User Manual

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 11 Subscriber Port Setup Screens

Table 113 IPBPVC: Slot (continued)

11.20 IPB Route Screen

Use this screen to set up and maintain the routing table for each domain. Each routing table

contains entries that, based on the destination IP address, control where the MSC forwards

packets. The MSC automatically creates routing table entries for each downlink interface and

for each edge router in the domain that the associated VLAN is in. You can create additional

entries by specifying the edge router to which the MSC should forward traffic for a particular

destination IP address or IP subnet.

To open this screen, click Port > IP Bridge > Route.

Figure 169 IPB Route

This field displays the port number of a port on this line card that has an IPB

This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier

(VCI). The VPI and VCI identify a IPB PVC (a channel).

This shows which ATM profile this channel uses.

This field displays IPB to indicate that this is an IPB PVC.

llc and vc are for a PVC running on Ethernet (IPoE), llc_r and vc_r are for a

PVC running on ATM (IPoA).

This is the VLAN ID assigned to frames received on this channel.

This is the priority value (0 to 7) added to incoming frames without a (IEEE

802.1p) priority tag.

Select the radio button in the Select column for an entry and click Delete to

remove the entry.

MSC1000G/1024G/1224G Series User's Guide

Msc1224g series Msc1000g series