Multicast Commands; Chapter 30 Multicast Commands; Multicast Commands Summary - ZyXEL Communications MSC1024G Series User Manual

C
H A P T E R
This chapter shows you how to use the
30.1 Commands Summary
multicast
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 323 multicast Commands
COMMAND
multicast bandwidth
groupmacaddr del
MSC1000G/1024G/1224G Series User's Guide

multicast Commands

multicast
commands. The P column on the right indicates the
multicast
default <bandwidth>
delete <index>
port disable <slot-
port>
enable <slot-
port>
set <slot-port>
<bandwidth>
show
<slot>|<slot-
port>
set <index> <start-
mcast-ip> <end-
mcast-ip>
<bandwidth>
show
<vid> <group-
mac-addr>
set <vid> <group-
mac-addr>
<giga-
port>|<slot-
port>
fix|forbid
30
commands.
DESCRIPTION
Sets the default bandwidth (1 ~100
000 kbps) allowed for multicast
channel(s) for which you have not set
the bandwidth settings.
Removes the specified multicast
bandwidth configuration.
Deactivates multicast bandwidth
setting on a port.
Activates multicast bandwidth setting
on a port.
Sets the maximum multicast
bandwidth allowed on a port.
Displays multicast bandwidth settings
on the specified line card or port.
Sets bandwidth allowed for the
specified multicast channel(s).
Displays multicast bandwidth settings
on the device.
Removes a static multicast group
entry by MAC address.
Configures static MAC multicast to
allow incoming frames based on
multicast MAC address(es) that you
specify.
P
M
M
M
M
M
L
M
L
M
M
669