Table of Contents
Advertisement
Figure 142 VDSL VLAN Setup
The following table describes the fields in this screen.
Table 94 VDSL Port Setup: VLAN Setup
LABEL
UP
PVID / Priority
TLS Enable
SVID / SPriority
Apply
Cancel
VID
Registration
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click this to return to the previous screen.
PVID refers to the customer's VLAN ID. In the first field, enter the VLAN ID (from 1
to 4094) to use for untagged frames received on this port.
In the second field, enter the priority level for the customer VLAN ID. "0" is the
lowest priority level and "7" is the highest.
Transparent LAN Service (also known as VLAN stacking or Q-in-Q) allows a
service provider to distinguish multiple customers VLANs, even those with the
same (customer-assigned) VLAN ID, within its network.
Once you enable TLS, all packets will be added an extra "VLAN tag" (SPVID/
SPriority) and forwarded toward Gigabit Ethernet interface(s).
Select this option to enable TLS (Transparent LAN Service). Clear this check box
to disable this feature. Refer to
SPVID refers to the service provider's VLAN ID (the outer VLAN tag). In the first
field, enter the service provider ID (from 1 to 4094) for frames received on this
port.
In the second field, enter the priority level for the service provider's VLAN ID. "0" is
the lowest priority level and "7" is the highest.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Type a VID (VLAN ID) to add this port as a member.
This must be the VLAN ID of a VLAN that is already configured. The port that you
are configuring must also be set to the fixed status in the VLAN.
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Chapter 11 Subscriber Port Setup Screens
Section 31.33 on page 742
for more information.
239
Advertisement
Table of Contents
Troubleshooting
