ZyXEL Communications MSC1024G Series User Manual page 648

Chapter 27 ima Commands
Table 318 ima Commands (continued)
COMMAND
mgtpvc
pvc
648
set <slot-group-vpi/
vci> <profile>
<llc|vcmux>
<management-ip>
<gateway-ip>
<pvid> <priority>
show <slot|slot-
group|slot-group-
vpi/vci>
delete <slot-group-vpi/
vci>
set <slot-group-vpi/
vci> <profile>
<mux> <pvid>
priority
< >
[tag|untag]
delete <slot-group-vpi/
vci>
DESCRIPTION
Sets a routed management PVC. If the
remote IMA device uses a routed
encapsulated (RFC 1483) PVC for
management traffic transmission, you
must configure the IES to use a routed
MGTPVC.
management-ip: This field displays the
IP address the remote IMA device uses to
connect with the IMA line card for
management traffic transmission.
gateway-ip: This field displays the IP
address a management computer uses to
connect with the IES and manage
management traffic.
Note: It is highly recommended
that you use the sys
reboot <seconds>
command before using any
commands that may lock
yourself out from managing
the device. Use the sys
reboot cancel
command to cancel the
scheduled reboot before
time is up when you are
sure that you have the
correct configuration.
Shows the mgtpvc to VLAN ID mappings
on the specified slot or slot and IMA
group.
Removes the specified management
PVC on the specified IMA group.
Sets a PVC used by an IMA line card for
mapping the specified single-tagged
frames (by VLAN ID and priority) with a
PVC (channel). For example, you can
map the single-tagged frames with VLAN
ID 100 and priority 7 with PVC 0/33, llc.
mux: the encapsulation method used for
this channel, llc or vcmux
tag|untag: specify whether to keep
VLAN tags (tag) or remove them
(untag) from a frame when the IMA line
card sends the frame out through this
channel. The default is untag.
Removes the specified PVC setting on
the specified IMA group.
MSC1000G/1024G/1224G Series User's Guide
P
M
L
M
M
M