This command allows you to apply an access control profile to the specified DSL link(s). You
can apply up to eight profiles to a subscriber port.
The following example applies the "example" rule to PVC.
ras> acl rule set 3-1-0/33 example
21.13.4 acl rule show Command
Syntax:
acl rule show <slot-port-vpi/vci>
This command displays the current access control rule assignment settings. The following
figure shows an example.
ras> acl rule show 3-1-0/33
pvc
-------------- --------------------------------
3-1-0/33
ras>
21.14 acl usbcastctrl Commands
Use the acl usbcastctrl commands to configure maximum bandwidth settings for all
upstream traffic entering the MSC.
21.14.1 acl usbcastctrl set
Syntax:
acl usbcastctrl set <rate>
This command sets the maximum bandwidth for all upstream broadcast traffic entering the
MSC.
The following figure shows an example.
ras> acl usbcastctrl enable
ras> acl usbcastctrl set 96
21.14.2 acl usbcastctrl show
Syntax:
acl usbcastctrl show
This command shows the maximum bandwidth for all upstream broadcast traffic entering the
MSC.
MSC1000G/1024G/1224G Series User's Guide
profile
example
Chapter 21 acl Commands
611