32.14 profile ratelimit Commands
Use these commands to configure Ethernet subscriber line ingress and egress rate profiles
32.14.1 profile ratelimit delete Command
Syntax:
profile ratelimit delete <profile>
This command removes the specified Ethernet subscriber port rate limit profile.
You cannot remove a rate limit profile that is currently in use.
32.14.2 profile ratelimit map Command
Syntax:
profile ratelimit map <profile>
This command displays the Ethernet subscriber port(s) to which the specified rate limit profile
is applied.
The following example displays the port mapping table for the
ras> profile ratelimit map DEFVAL
slot
---- ------------------------------------------------------------------------
123456789012345678901234567890123456789012345678901234567890123456789012
3
4 ------------------------------------------------
5 ------------------------------------------------
6 ------------------------------------------------
7 VVVVVVVVVVVVVVVVVVVV
8 VVVVVVVVVVVVVVVVVVVV
9 ------------------------
10 ------------------------
32.14.3 profile ratelimit set Command
Syntax:
profile ratelimit set <profile> <ingress-rate> <egress-rate>
where:
<ingress
-rate>
<egress-
rate>
MSC1000G/1024G/1224G Series User's Guide
port
1
2
=
The maximum allowed aggregate data transfer rate (in Kbps) for traffic coming in
from the subscriber. 0~99968 in kbps in steps of 64 Kbps. 0 means no limit.
=
The maximum allowed aggregate data transfer rate (in Kbps) for traffic coming
going to the subscriber. 0~99968 in Kbps in steps of 64 Kbps. 0 means no limit.
Chapter 32 profile Commands
DEFVAL
3
4
5
rate limit profile.
6
7
791