Switch Setup Dot3Ad Screen - ZyXEL Communications MSC1024G Series User Manual

15.6 Switch Setup Dot3ad Screen

Click Switch > Switch Setup > Dot3ad to display the screen as shown.
Figure 328 Switch Setup Dot3ad
The following table describes the labels in this screen.
Table 243 Switch Setup Dot3ad
LABEL
LACP Priority
LACP Timeout
Group ID
Active
Dynamic (LACP)
Port
Group
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Type a number between 1 and 65,535 for the LACP system priority. The switch
with the lowest system priority (and lowest port number if system priority is the
same) becomes the LACP "server". The LACP "server" controls the operation of
LACP setup. Enter a number to set the priority of an active port using Link
Aggregate Control Protocol (LACP). The smaller the number, the higher the
priority level.
LACP timeout is the time interval between the individual port exchanges of LACP
packets in order to check that the peer port in the trunk group is still up. If a port
does not respond after three tries, then it is deemed to be "down" and is removed
from the trunk. Set a short timeout (one second) for busy trunked links to ensure
that disabled ports are removed from the trunk group as soon as possible. Select
either short (1 second) or long (30 seconds).
This column displays the names of the trunk groups for the management switch
card's Ethernet ports. In the MSC1000G, tsub is for the subtending ports and tup
is for the uplink ports.
Select this check box to turn on a trunk group.
Select this check box to use Link Aggregate Control Protocol (LACP), to
dynamically create and manage the trunk group.
This column lists the management switch card's Gigabit Ethernet interfaces.
This column displays to which trunk group an MSC Gigabit Ethernet interface
belongs.
Chapter 15 Switch Screens
477