ZyXEL Communications MSC1024G Series User Manual page 243

Table 96 Port > VDSL2 (continued)
LABEL
PVID / Priority
VLAN
PVLAN
Apply
Cancel
Copy
ID
State
Card Type
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to
untagged frames received on this port. If an untagged frame matches a PVLAN
setting, the system uses the PVLAN setting instead.
Click the Setup button to open a screen where you can configure the VLAN
settings for the VDSL port. See
Click the Setup button to open a screen where you can configure Protocol VLAN
(PVLAN) settings for the VDSL port. See
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Do the following to copy DSL settings from one DSL port to another DSL port or
ports.
1. Use the Slot and Port drop-down list boxes and the Load button to select the
number of the DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 145 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
This column lists the slot numbers of the line cards. Click the ID number of an
active DSL line card to go to a screen where you can copy an DSL port's settings
to another DSL port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974 for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
Chapter 11 Subscriber Port Setup Screens
Section 11.8.8 on page 238.
Section 11.8.9 on page 240.
243