<ip-address>
<mask>
<vid>
This command clears the specified entries in the Address Resolution Protocol table(s).
31.16.3 port ipbpvc arpproxy show Command
Syntax:
port ipbpvc arpproxy show
This command displays how long the device stores the IP addresses of IP bridge devices in the
Address Resolution Protocol table.
The following is an example.
ras> port ipbpvc arpproxy show
age=300 (sec)
31.17 IP Bridge PVC Commands
Use the port ipbpvc delete, set (see
Section 31.22.5 on page
bridge.
IP bridge PVCs are similar to regular PVCs and are endpoints of the IP bridge. In addition, IP
bridge PVCs are one of two types, IP over Ethernet or IP over ATM, depending on the
underlying network.
The PVID is used to identify the domain the PVC is in, so the PVID must be in a domain.
31.18 port ipbpvc delete Command
Syntax:
port ipbpvc delete <slot-port-vpi/vci>
where
vpi/vci
This command deletes the specified PVC channel in an IP bridge.
MSC1000G/1024G/1224G Series User's Guide
IP address, in dotted decimal notation.
=
Number of bits <1..32> in the subnet mask.
=
The ID (<1..4094>) of the VLAN.
=
728) commands to set up and maintain PVCs for subscribers in an IP
The VPI and VCI of an individual PVC.
=
Chapter 31 port Commands
Section 31.22.4 on page
728) and show (see
719