Show Linerate Command - ZyXEL Communications MSC1024G Series User Manual

The following table describes labels in this example.
Table 338 show lineinfo Command Display (VoIP)
LABEL
sipLocalUri
sipRemoteUri
rtpTxCodecType
rtpRxCodecType
rtpTxPt
rtpRxPt
rtpLocalIp
rtpRemoteIp
rtpLocalPort
rtpRemotePort

33.3.18 show linerate Command

Syntax:
show linerate <slot-port>
This command displays an ADSL port's line rate information.
The following example displays the line operating values for ADSL port 5 on the line card in
slot 7.
ras> show linerate 7-5
slot-port=7-5, DSL line rate
link
payload rate
actual rate
attainable rate(kbps)=
noise margin
attenuation
The following table describes labels in this example.
Table 339 Line Rate Information
LABEL
The rate fields display the transmission rates. "Line Down" indicates that the ADSL port is not
connected to a subscriber.
up/down
stream
payload rate
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This shows the SIP local URI.
This shows the SIP remote URI.
This shows the voice codec used for transmitting data.
This shows the voice codec used for receiving data.
This shows the total number of RTP packets transmitted from this port since the
system was started.
This shows the total number of RTP packets received by this port since the
system was started.
This is the local IP address.
This is the remote IP address.
This is the local port used for VoIP.
This is the port on the remote device used for VoIP.
= link_up
upstream downstream
---------- ----------
(kbps)= 999
(kbps)= 1008
1013
(dB)= 18.8
(dB)= 0.8
DESCRIPTION
Upstream refers to traffic coming into the DSL line card from the subscriber's
ADSL modem or router. Downstream refers to traffic going out from the DSL line
card to the subscriber's ADSL modem or router.
These are the data (the payload data without transport layer protocol headers and
traffic) transfer rates (in Kbps) at which the port is receiving and sending data.
Chapter 33 show Commands
23995
24004
24634
12.5
0.0
845