ZyXEL Communications MSC1024G Series User Manual page 647

Table 318 ima Commands (continued)
COMMAND
mgtpvc
MSC1000G/1024G/1224G Series User's Guide
minlin <slot-gid>
k <minlink>
versio <gid> <1.0|1.1>
n
set <slot-group-vpi/
vci> <profile>
<llc|vcmux> <pvid>
<priority>
Chapter 27 ima Commands
DESCRIPTION
Enter the minimum number of E1 lines
(1~8) the specified IMA group should
support. Once all of these E1 lines link
up, the IMA group automatically
activates. Disconnecting one of these E1
lines deactivates this IMA group. The
fewer E1 lines you configure here the less
bandwidth the IMA group can guarantee.
Select the version of IMA protocol this
IMA line card uses to communicate with
the peer IMA devices. Both peers must
use the same IMA protocol version.
Sets a bridged management PVC. When
the IES (with an IMA line card installed) is
used in a remote site (see IMA
Application on page 45), you must set a
management PVC used to transmit
management traffic only to a remote IES
through an IMA connection.
Note: It is highly recommended
that you use the sys
reboot <seconds>
command before using any
commands that may lock
yourself out from managing
the device. Use the sys
reboot cancel
command to cancel the
scheduled reboot before
time is up when you are
sure that you have the
correct configuration.
P
M
M
M
647