C
H A P T E R
This chapter describes the alarm management commands.
22.1 General alarm Command Parameters
The following table describes commonly used
Table 307 General alarm Command Parameters
NOTATION
alarm
severity
condition
sdate
edate
target
for|rev
detail
fac
22.2 alarm Commands Summary
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 308 alarm Commands
COMMAND
alarm
clear
cutoff
MSC1000G/1024G/1224G Series User's Guide
alarm Commands
DESCRIPTION
Specify a category of alarms.
represents equipment alarms.
eqpt
dsl
represents Digital Subscriber Line (DSL) alarms.
enet
represents Ethernet alarms.
represents system alarms.
sys
all
specifies every alarm category.
Specify an alarm severity level (
Specify an alarm condition. condition|code|all
Specify a start date in yyyy/mm/dd format.
Specify an end date in yyyy/mm/dd format.
snmp|syslog|all|none
category.
Specify the displaying order. for = forward, rev = reverse
Display more comprehensive alarm condition descriptions.
This is an alarm category. Options are: local1~local7
commands. The P column on the right indicates the
alarm
command parameter notation.
alarm
critical
,
major
,
minor
'none' disables alarm reports on this alarm
DESCRIPTION
Erases historic alarm entries.
Cancels an alarm. This stops the
sending of the alarm signal current.
22
,
info
or
all
).
P
M
M
613