Sys Snmp Show Command; Sys Snmp User Command - ZyXEL Communications MSC1024G Series User Manual

35.4.5 sys snmp show Command

Syntax:
sys snmp show
This command displays the current SNMP get community, set community, trap community
and trap destination settings. The following is an example.
ras> sys snmp show
[community]
get community : Get123
set community : Set123
trap community: public
[trap destination]
1: 192.168.1.36:162
2: 0.0.0.0:0
3: 0.0.0.0:0
4: 0.0.0.0:0
ras>

35.4.6 sys snmp user Command

Syntax:
sys snmp user <name> noauth|auth|priv md5|sha des|aes
where
<name>
noauth
auth
priv
md5|sha
des|aes
This command sets the user authentication and data encryption settings for SNMPv3. The
following example enables SNMPv3 SHA user authentication with AES data encryption.
ras> sys snmp user example auth sha aes
MSC1000G/1024G/1224G Series User's Guide
= User name for SNMPv3 authentication.
= Disables ( noauth ) SNMPv3 user authentication and encryption for SNMP
communication.
= Enables SNMPv3 user authentication.
Enables SNMPv3 user authentication and encryption for SNMP
=
communication using a private key generated from the password.
Authentication method. MD5 (Message Digest 5) produces a 128-bit digest to
=
authenticate packet data. SHA (Secure Hash Algorithm) produces a 160-bit
digest to authenticate packet data.
Use md5 for minimal security and
= Encryption method. Data Encryption Standard (DES) is a widely used method
of data encryption using a secret key. DES applies a 56-bit key to each 64-bit
block of data.
Advanced Encryption Standard (AES) is a newer method of data encryption
that also uses a secret key. AES is more secure than DES.
Chapter 35 sys Commands
sha for maximum security.
925