Table of Contents
Advertisement
Use these commands to configure Transparent LAN Service (TLS) settings on the Ethernet
subscriber port(s). Once you enable TLS, all packets will be added an extra "VLAN tag"
(SPVID/SPriority) and forwarded toward Gigabit Ethernet interface(s). If you configure an
ENET PVID setting and enable TLS, the system does not apply the PVID.
The following shows an example.
• Enables TLS on port 5 on the Ethernet line card in slot 4.
• Configures the service provider's VID to 10 and priority to 7 (highest priority).
• Displays the port's TLS settings.
ras> port enet tls enable 4-5
ras> port enet tls set 4-5 10 7
ras> port enet tls show 4-5
slot-port
tls state
tls vid
tls priority
31.10.14 port enet vlan Commands
Syntax:
port enet vlan <slot-port> <vid> <registration> <tag>
where
<vid>
<registration>
<tag>
This command sets the VLAN settings on the Ethernet subscriber port(s).
The following example sets port 5 on the ELC in slot 4 to join VLAN 6. The port also adds a
tag to frames.
ras> port enet vlan 4-5 6 join tag
31.11 G.bond Commands
This section shows how to set up G.bond settings on your device. G.bond (also known as port
bonding) allows subscribers to connect to an ISP using data streams spread over multiple DSL
lines. The total available bandwidth for the subscriber then becomes the sum of the bandwidth
available for each of the subscriber's line connections. As well as extra bandwidth, additional
DSL lines also provide backup support.
MSC1000G/1024G/1224G Series User's Guide
:4-5
:enable
:10
:7
Enter a VID (VLAN ID) to add this channel as a member.
=
This must be the VLAN ID of a VLAN that is already configured. The
port that you are configuring must also be set to the fixed status in
the VLAN.
Enter
to have the port be a member of the specified VLAN.
=
join
Enter
leave
to remove the port from the specified VLAN.
=
Enter
tag
to add a tag to all frames transmitted on this port.
Enter
to not add tags.
untag
Chapter 31 port Commands
715
Advertisement
Table of Contents
Troubleshooting
