Show Ip Pim Interface; Ip Pim Hello-Interval - NETGEAR ProSafe GSM7224P User Manual

ip pim hello-interval

This command configures the transmission frequency of PIM Hello messages between PIM
enabled neighbors. This field has a range of 0 to 18000 seconds.
Default
30
Format
ip pim hello-interval <0-18000>
Mode
Interface Config
no ip pim hello-interval
This command resets the transmission frequency of hello messages between PIM enabled
neighbors to its default value.
Format
no ip pim hello-interval
Mode
Interface Config

show ip pim interface

This command displays the PIM Interface status parameters. If the interface number is not
specified, this command displays the status parameters of all the PIM enabled interfaces.
Format
show ip pim interface <unit/slot/port>
Modes
Privileged EXEC
Term Definition
Mode
Active PIM protocol
Interface
Interface number.
Hello Interval
Hello interval value. The frequency at which PIM hello messages are transmitted on this
interface. By default, the value is 30 seconds.
Join-prune
Join-prune interval value.
Interval
DR Priority
DR Priority configured on this Interface. This is not applicable if the interface mode is
Dense
BSR Border
Is this interface configured as a BSR Border?
Neighbor Count
Number of PIM Neighbors learnt on this interface. This field is displayed only when the
interface is operational.
Designated
IP Address of the elected DR on the Interface. This field is displayed only when the
-Router
interface is Operational.
Example 1:
(Switch) #show ip pim interface
Interface 1/0/1
Mode Sparse
ProSafe Managed Switch
IP Multicast Commands
330