Setting The Transmission Confirmation Stamp - Pitney Bowes 4100 Operator's Manual

2. Press PROGRAM, J, 1, 4, ENTER. The display shows your fax's
current setting:
Silent Mode:
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
3. To change the setting, press PROGRAM once or twice until your
chosen setting appears. In this example, we've chosen On.
Silent Mode:
Note: Don't be confused. If silent mode is On, the machine will be
quiet. If silent mode is Off, the machine will ring and beep as
usual. (In other words, the On/Off refers to the silent mode
setting, not to the sound itself!)
4. Press ENTER to save the setting.

Setting the transmission confirmation stamp

You can set your fax machine so that it will automatically place a small
stamp mark on the front of each original document that it successfully
scans.
Note: This feature is available only for documents scanned
through the document feeder.
Important: Be sure that this feature is turned off if you are sending
original documents you don't want the fax to stamp.
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press COPY/FAX to change to Fax mode.
2. Press PROGRAM, J, 1, 5, ENTER. The display shows your fax's
current stamp setting:
Stamp:
If the setting you see is acceptable, skip to step 4.
Otherwise, proceed to step 3.
Off
Program/Enter
On
Program/Enter
Off
Program/Enter
87