Table of Contents
Advertisement
Transport screws
Your fax machine is shipped with transport screws for protecting your fax
machine's mirror carriage during shipping. They will be removed by your
Pitney Bowes representative.
Important:
Be sure that you do not turn the power on until after
the screws have been removed. Otherwise, damage could
result.
1. Remove the four transport screws, as shown.
2. Get the protection seals from your manual kit, and attach one
protection seal on each transport screw's now-open hole. This shields
the hole while you are using the machine.
Important:
Before you use the machine, you must turn off the
transport mode (see page XX).
Note:
Be sure to save the screws for reshipment. If you must
ship your machine for some reason, turn off the
transport mode, turn the power off and then undo
the above procedure as follows:
—
—
Remove the seals (reversing step 2);
Reinstall the screws (reversing step 1).
27
Advertisement
Table of Contents
