Table of Contents
Advertisement
Redialing manually
You always can redial fax or voice calls manually; and, again, you must
redial manually if you dialed by using either the monitor speaker or a
handset.
To redial a fax call manually without using the monitor speaker or an
optional handset:
1. Confirm that the document is still in the feeder and that your desired
resolution and contrast settings are still correct.
2. Press REDIAL/PAUSE.
To redial a fax call manually by using either the monitor speaker or the
handset:
1. Confirm that the document is still in the feeder and that your desired
resolution and contrast settings are still correct.
2. Obtain a dial tone: either press MONITOR/CALL or lift the handset.
3. Press REDIAL/PAUSE.
4. When you hear fax tones from the remote unit, press START.
Note: If a person answers the phone, tell him or her you're trying to
send a fax. When his/her machine sends you fax tones, then
press START.
To redial a voice call manually using an optional handset:
1. Obtain a dial tone: either press MONITOR/CALL or lift the handset.
2. Press REDIAL/PAUSE. When the other person answers, speak to
him/her on the handset.
Making redial settings
It's up to you how many times the fax redials a number and how long it
waits during redials (that's called the redial interval). Here's how to make
those settings:
1. Change to the Fax mode, then press PROGRAM, J, 0, 6, ENTER.
Set # Of Redials
#
If the number of redialings you see is acceptable, skip to step 3.
Otherwise, proceed to step 2.
(02-15) :
02
60
Advertisement
Table of Contents
