Plug In And Power Up - Pitney Bowes 4100 Operator's Manual

Plug in and power up

1. Plug one end of the
telephone line cord into
the LINE jack on the
machine's rear side.
Plug the other end of
the cord into a standard
telephone wall jack, just
as you would plug in a
phone.
2. Plug the non-pronged end of the AC power cord into the AC power
cord jack on the left side of the machine.
3. Plug the pronged end of the AC power cord into a 120 VAC electric
outlet (preferably on a surge suppressor, as mentioned on page 26).
Important: Be sure that you do not turn the power on (next step)
until after you have removed the transport screws (see
page 27).
4. Use the AC power switch to turn on your machine. The markings are
international standards: means On,
It will take a few seconds for the machine to warm up. The display will
show:
When the machine is ready to use (standby mode), you will see either...
Fax Ready
Apr 14 1998 15:30
Fax mode
If the machine beeps, its ALARM light glows and the display shows an
error message, this means there is a problem of some sort. Please consult
"Just in case...," beginning on page 226.
** Please Wait **
... or ...
39
means Off.
Copy Ready Num:
C1:LTR
Copy mode
1
100%